Black Widow V1 to V2 Conversion

Remove the 4 screws from the FRONT of the machine with a 4mm allen wrench. 2 will be found on the top-sides and 2 towards the bottom-sides.
Remove the 2 screws from the REAR-top and the 2 screws from the BOTTOM (near the back) of the machine with a 3mm allen wrench.
Slide the rear cover off of the machine and place to the side. BE CAREFUL NOT TO BREAK ANY WIRES AS YOU SLIDE THE COVER BACK. THE METAL BRACKETS WILL CATCH THE WIRES.
Unplug all cables from the old control board. Although all cables are labeled, you may want to take a few pictures to refer to later when plugging everything back in.
Remove the 4 screws holding the old control board to the machine using a small phillips head screwdriver. Remove the old board completely.
Insert the new control board and put it all back together again. Attach the 4 mounting screws, attach all cables, slide the cover back on, and reattach the remaining screws.
Install the Black Widow Key Machine V2 app.	You may want to do a DATA EXPORT (Device > Settings) from your V1 app and then do a DATA IMPORT into your V2 app if you would like to save your Cut History, Favorites, and Custom Keys. After installing this new motion board, you will no longer be able to control your machine using your old V1 app.